no spark

i was wondering if anybody has had a failure with their pickup coil otherwise knownas an ignition pulse generator.I think this is my problem I suddenly lost spark,swapped out CDI box no help took it to the dealer they said it was the stator so i put in a WB high output one but you have to use the pickup coil off of your original stator still no spark

[RIZZO]

Try a new plug cap, plug wire, check your grounds, check your on/off or kill switch, you may need a new coil.
have your parts tested before you go spend alot of money on new ones........etc

[MichaelS693]

new coil

Well put the new coil on the new stator it fired once and it was cold so it died.Tried to fire it again and no spark again. I have no clue where to go from here.

[Leo]

have you checked the pickup coil (that reads off the flywheel)?

have you checked to make sure it's not a problem with your kill switch / ignition switch grounding out the coil all the time?

service manual is down stairs.. but I'd start by checking to make sure both sides of the coil weren't grounded...

Leo

[deansfastway]

its cheaper to buy a $15 ohmeter and a book than to buy a source coil. GOOD LUCK , You can do it! just try!