wont start,, need help or manual

[bobby bo]

i started the bike to warm it up. started right up,, let it warm up. turned off. now it wont start. i check the carb thats good, the plug is wet. spark looks weak but i dont have another 250r to compare. cleaned the stator and flywheel. has new plug. after a few kicks the plug is very wet. can that be broken reeds?? oh i swapped cdi boxes also... any help would be great. thanks

[250R-Dee]

Go to everything2stroke.com and download the manual from the manuals section.

[zedicus00]

turn the gas off pull the plug out and kick it a bunch..... then put a new plug in an it should go. sounds like u seriously wet fouled it. dont idle around on a 2 stroke then shut it off, ride it an romp on it, after its a lil warm.

[bobby bo]

thanks for the manual.. the plug is brand new,, its white..

[bobby bo]

ok i did the tests on the electrical.. i ohmed out the coil from the connector on the back to the boot nothing, removed boot still nothing. the book says its supposed to have around 7 ohms. has anyone ohmed theirs out and got the proper reading??

[Dave83]

You got your ohmmeter on the correct range.I did that once,ohm everything and would get nothing on the coil.I had to go to a different range on the meter.

[bobby bo]

also are the reeds suppossed to be close, no gap. mine have a gap on both.

[bobby bo]

Originally posted by Dave83
You got your ohmmeter on the correct range.I did that once,ohm everything and would get nothing on the coil.I had to go to a different range on the meter.


your right,, i reread it, i was looking for 3-5 ohms,, where i need to look for 3-5k ohms,, thanks