Razorback
05-17-2002, 12:55 PM
i just got my twin-row RAD carrier with external zerk. i'm not going to install it until my lsr axle gets in, but i have some questions for those who have this carrier.
i assume that the zerk side goes to the sprocket side. i know this is probably a stupid question, just want to make sure i put it in correctly. also, what position do you install the carrier. so, if you were looking from the side at the zerk and chain adjustment holes, where would you set the zerk when first installing? if it was like a clock, would you install it at 12:00, 3:00, etc?
also, do you find adjusting the chain difficult at all. seems like it might be troublesome to get something in those holes to get much leverage.
for those who will undoubtedly make the comment, the only instructions with it are to grease it.
thanks.
i assume that the zerk side goes to the sprocket side. i know this is probably a stupid question, just want to make sure i put it in correctly. also, what position do you install the carrier. so, if you were looking from the side at the zerk and chain adjustment holes, where would you set the zerk when first installing? if it was like a clock, would you install it at 12:00, 3:00, etc?
also, do you find adjusting the chain difficult at all. seems like it might be troublesome to get something in those holes to get much leverage.
for those who will undoubtedly make the comment, the only instructions with it are to grease it.
thanks.