450r in progress::

[xsr_racing28c]

here is my 450r that i have been slowly putting money into... being in college, i cannot afford everything at once, but i think it is turning out to be a pretty nice ride!!!


Mod List:
HMF Exhaust
Dyno Jet kit
Hinson Clutch Basket

Burgard +2 a arms
Burgard hd tie rods
LSR +4 axle
Works Tri-rate w/ Rezzy fronts

Brugard rear Beads (Trans red pc'd rings)
Douglas .190 fronts
18x10x8 Kenda Klaw mx rears
20x6x10 Kenda Klaw mx fronts
trans red pc'd rear hubs
black w/silver metalflake pc'd rear caliper
black pc'd front and rear bumpers

Pro Taper bars ( Windham bend)
Ac pro-peg nerfs
Maier Scooped hood

[xsr_racing28c]

~~~~

[xsr_racing28c]

side view

[Sportrax10]

Looks good.. :macho

[Out_Sider]

looks good but i would have just had your stock shocks converted to zps

[culookn]

i like it, looks like youve been doing some wheelies with that grab bar bent up.

[dtmichau]

Hey man, i hear you about not being able to afford everything due to college. I am a junior in a nursing program in FL and find it difficult to find time to work and save for toys to add to my 450r. I am slowly peicing my toy together. Ill post a pic or two in about a month when i get some of the stuff done to it.

[Jersey450R]

are you going to be a male nurse Focker?

[xsr_racing28c]

haha... once yur outta school, you should be makin fat cash though, so its all good!! yea post a pic... and yes i have been doing a few wheelies... we were shooting footage for about 6 hours and right when we about finished i decided to try a 4th gear wheelie and point at the camera... well it didn't go so well and i ended up flipin it over backwards, and rolling it 3 times..lol... i'm fine, but the quad suffered two sheared off ball joints and a bent tie rod.. and the bumper and tailight were wiped out....

[Punk'd]

lookin awesome bro

[Leschj03]

im not sure but in that front view pic it looks like your top ball joint is threaded way to far out, and thats not good, just trying to help out

[400EXracer74]

yea on those burgard a-arms the bottom and top ball joints come out but the bottom should be screwed in as fas as it can go to make it as strong as it should be. its not another way to make it wider or adjust it.

[xsr_racing28c]

---yea the top one is a little too far out, but as compared to how they were shipped its only about 3 threads difference.. the reason its not the same is cuz i broke off the whole left side ( both ball joints) and replaced them with new ones, so i didn't get the adjust them yet... thanks for noticing it though...

[fatkid400]

Originally posted by Jersey450R
are you going to be a male nurse Focker?

THATS NOT RIGHT!!!funny as **** but not right:blah: