Log in

View Full Version : info on carrier, nut,bearings



ranger400ex
05-16-2002, 02:44 PM
Hey guys just got with Bob Meszaro of Meszaro's Motorsports and he is manufacturing axle nuts and carrier for the 400 and 250r. Check out his site www.meszmoto.com. I ordered a twin row carrier and nut. I plan on taking plenty of pictures and giving a review after a couple hard rides. Anything has got to be better than my rad nut, broke it twice(split the ring that borders the ring on the axle) guess this happens alot. Anyway Bob said that the reason most of the other do this is because they don't spec them jsut like the factory nu, which makes since(guess they are over .007 off from the factoy spec which wont work properly) anyway I will keep you guys up to date. And for those of you who are wanting factory replacement bearings he has the set of two and seals cheaper than everywhere else.

He also warned to stay away from the tapered due to not being able to tighten it up and seal properly therefore more sh#t is allowed into the carrier. He recommended twin row, or stick with stock.

later

BMW

ranger400ex
05-16-2002, 02:45 PM
here is the nut