where to get 426 kit

[sam the brave]

i am going to bore out my motor and from what i hear this is the best bore.
who makes the kit?
could somone post a link to the site

[theTman]

not to be an ***....but id bring it back to stock before you blow this one too:rolleyes:

[sam the brave]

its not me that blew it this time the carb sucked in dirt from the vent on the side of intake tube there was a crack in that plactic chamber.
http://www.imagestation.com/picture/sraid165/p8e1d9ee868453c5290959ef558c5e79d/f4669ed0.jpg

[TC426EX]

There is no 426 "kit". The reason there is a 440 kit is because it comes with the sleeve you need to get pressed in for that piston. When building a 426, youll have to just order the piston kit (comes w/rings, wristpin, circlips) by itself. The size of the piston youll need is 88mm and youll have to decide what kind of compression you want to run, there are many options. Then youll have to get your cylinder bored .120 over for the 426. Its helpful if you include the piston youll be using with the cylinder when you take it/send it to get bored so they can do it perfect. From there, youll just need a top end gasket set and a new cam if you decide to get one, and youll be all set....

[sam the brave]

ok thanks for that info

[rYan01400EX]

LZ Racing will bore your motor for you.