LSR axle

[4trax250x81]

I just got my LSR axcalibur axle for my 250x and it seems like the holes for the cotter pin dont match up with the slots on the castle nut. You can get it in one of the holes but the other hole is covered halfway by the castle nut. Anyone else have this, if yes what did you do? Do I just need a smaller cotter pin? Thanks

[TC426EX]

yeah thats common, you gotta play with it a bit. Just another pain in the a s s

[400exrider707]

try hitting the castle nuts with an impact wrench. thats what I did, cause I got sick of my hubs loosening up. Then I had to lightly tap the cotter pins in with a hammer, haven't had a problem since.:cool: