which handle bars

[TheFontMaster]

I know I'm gonna be getting renthals. I don't know which bend would best. I liked what was on my 300ex, but I don't know what bend they were. They were a little taller, and less swept back from stock, if that helps any.

[praetorian]

Plus 1" stem and CR High Bend is the way to go. Unless you are tall, then go plus 2"-3" with the CR high bend.

[TheFontMaster]

Well I'm running a stock stem on the R for now, along with the stock handlebar clamps.

[JDiablo]

i've got a set for you cheap if you want

[NacsMXer]

Get the Tag Mini Works bend or the Fly Mini bend. They are much taller than CR Highs, a little more straight and not as wide. I'm going to try this bend this summer along with some Rox risers to get my body in a more upright position. This gives you more control of the quad in general. I've seen many people running CR High bends (much lower than stock bend) with the stock stem putting your body into a "hunched over" position. I've never understood the appeal of that.

[aci clay]

try some pro tapers in cr high or double high, get the oversize bar adapters and they'll give about another 3/4" of lift with the stock stem.

[TheFontMaster]

Originally posted by 300exrida
i've got a set for you cheap if you want

How much, what bend, and how much have you used them?

[JDiablo]

Originally posted by TheFontMaster
How much, what bend, and how much have you used them?

60 used them once because i needed a set to go riding and the stockers where bent like crazy,and they are ABOUT the same as a 400ex bend,just instead the handlebar handles are upward just a lil bit more