Stripped drain bolt!!!!

[Thumperz4Life]

I stripped the drain bolt on my case!!!! Whats the best way to solve this? I already know the quick and easy teflon tape method, but im looking along the lines of a tap or something similar, thanks!

[zedicus00]

yur option are

helli coil
tapp for a lt250 plug
get a self tapping fram plug from an auto store, (you will hav to cut it off)
new cases.

good luck.

*note: if u tap it coat whatever u r tapping it with in axle grease it will help keep the metal from getting in the enging.

[Eddiesanders250]

did you strip the bolt or the cASE?

[Thumperz4Life]

I stripped the case :(

[CHAR250R]

Helicoil. I did one last week. Very easy. Almost as good as new. :D

[JTRtrx250r]

another trick is to use low air pressure in the case and have someone hold a vaccume while your drilling, tapping. Just another way to keep chit out;) :D

Zeds on the right track w/ his post, then again so is Char

Good Luck bro!

[Thumperz4Life]

What up Jeremy! Good to hear from ya again, this is Stealth-R from the infamous RRIDERS. Anyway, thanks for the advise ;)

[ESR350r]

When i stripped mine i went to a local auto store and got a couple that were alittle bit larger diameter. Then i just rethreaded the whole to the larger size a flushed out the cases really well. Works fine now. If you go that route get a plug that has a magnet in it if at all possible.