rebuild question

[xX-400racer-Xx]

i was just wondering, how do you get the wrist pin out of the stock piston?? i ahve looked at it and it looks like theres a notch to pull a clip out but thats all the farther i have gotten with it.:confused:

[duke416ex]

Pull the clips out and the pin will slide out with some pressure.

[BLEEDRED]

Just be sure you are careful when you pop the cir clips out. They can pop out and shoot across the room. Also make sure you don't drop them in the bottom end. I usually take one side out, remove the wrist pin and piston and then take the other side out on the bench.

[xX-400racer-Xx]

how exactly do you pull the cir-clips out ?

[BLEEDRED]

Stick a small screwdriver in the groove and pop them out.

[xX-400racer-Xx]

thanks. just makin sure before i go hackin on the motor. red u have a pm

thanks guys!!!:D :D :D :D