What do you think of this Bearing Carrier???

[sleepin400]

I'm needing a new bearing carrier and I started looking around for one.

I foung this:

Burgard Cycle Bearing Carrier ......for $150

It has a grease jerk on it and is made from billet aluminum. Says its twice as strong as stock.

Anyone have any expierence with this Carrier?

Thanks

[mx400]

burgard has always made good products. the grease zerk is a major plus. my LSR machined has a grease zerk and it does wonders.

[hondarider2006]

I have the Burgard twin row and love it. Bearings lasted MUCH longer than a set of stockers, and you can grease it. Worth the $150 IMO:cool:

[sleepin400]

thanks for the reply's guys,

and hey, hondarider2006,

Does the kit have everthing in it needed to replace your bearring carrier? Bearings, Carrier, and all other parts needed to do the swap?

sorry, just wanting to make sure. I think I'm going to go w/ them, I need one bad, and the Zerk could help extend these things quite a bit I think.


Thanks

[Pappy]

all you have to do is grease the carrier and install it. beyond that the only parts needed are the tools to do the job.

all i run is burgard carriers.

[sleepin400]

all you have to do is grease the carrier and install it. beyond that the only parts needed are the tools to do the job.

Sweetm I'm going to go a head and order one this week.

thanks for all the replys/help.

:cool: