cant get a nut

[baggingears11]

hey thanks for any replies but is there a tork spec for the clutch bolt i dont belive i can tork it down since it keep's moving. i was planning on hiting with a impact and tighten it and call it a day but dont wana mess any thing up hast makes wast

[dork]

if you mean the clutch nut, you can make a holder out of an old steel clutch plate, just weld a handle to it. but they don't always hold. depending on the model, the torque is usually 50-80 ft lbs, so a few wacks with a 1/2 impact is plenty.

put the bike into a high gear, sit on the rear tire, torque to 80 ft lbs,

your done

Jesse

[baggingears11]

thanks a million for your help