FoxRacing81
03-25-2005, 06:13 AM
Well I cranked on mine so hard last night all I did was turn the motor over. This ***** won't come loose! It is reverse threads correct? So it would be like tightening a regular thread? I am pretty sure of that I just have.
Anyway, the nut didn't even move the slightest bit. Not even a like a quarter of a millimeter. This thing is on there tight!
Anyone have any ideas on how to get this sucker off, let me know.
I don't get this. I just tighten my axle nut with no loctite or nothing and it stays on fine. But for my wheel hubs I used red loctite all over the threads and the thickest cotter pins I could find that would fit (there about the width of a pencil) and my wheel hubs still manage to come loose some how. I don't get it.
-Mx
Anyway, the nut didn't even move the slightest bit. Not even a like a quarter of a millimeter. This thing is on there tight!
Anyone have any ideas on how to get this sucker off, let me know.
I don't get this. I just tighten my axle nut with no loctite or nothing and it stays on fine. But for my wheel hubs I used red loctite all over the threads and the thickest cotter pins I could find that would fit (there about the width of a pencil) and my wheel hubs still manage to come loose some how. I don't get it.
-Mx