oriclez
03-24-2005, 09:31 PM
On my 300ex I have it bored and stroked to a 406. It was running fine for a while than the starter blew. I waited a couple months and decided to fix it. I replaced the starter and started it up. I noticed that when I would pin it and my engine would bog down and after a few seconds it would kick in. I figured my needle was off. So I pulled my carb off and saw a gas puddle laying in the intake ports. I went up to the biggest jet I had on hand which was a 130 something and reminded myself to change it down the road but I forgot until now. Figured I'd need to adjust my intake valves. But while I'm at it I would rejet. What size jet should I go up to. My mods are Suppertrap E.A.R Exhaust, Uni Airfilter, Powroll Valve Springs, Hardend Rockers, Wisceo 11:1 Piston, Bored and stroked to 406, and headowrk.