PDA

View Full Version : blaster breaks


sandnmyteeth2
03-17-2005, 08:32 PM
Has any body converted stock blaster breaks to hydraulic using banshee parts or others? THANKS
JDiablo
03-17-2005, 08:36 PM
www.eastcoastatv.com i was on there today adn i seen something about blaster brakes,go take a sneek over there
bradley300
03-18-2005, 08:02 AM
you can use the 2003 spindles and all raptor front brake componets or east coast makes a bracket to use the stock spindles and banshee/warrior brakes. for the rear, get an 03 bearing carrier and banshee axle (its wider too) now all the rear brakes from a raptor will bolt up (including a new pedal), but you will need a 03 footpeg also
kfxwizzard400
08-30-2005, 10:47 AM
trengaracing.com... the only place u should buy hydralic back brakes. all others with the same design are just gokart brakes. trenga was the first ones to make the hydralic brake in 94' so ride trenda or have problems with your go kart brakes.
flyin#5
08-30-2005, 11:09 AM
Originally posted by kfxwizzard400
trengaracing.com... the only place u should buy hydralic back brakes. all others with the same design are just gokart brakes. trenga was the first ones to make the hydralic brake in 94' so ride trenda or have problems with your go kart brakes.

i wouldnt give a dime of my money to eric trenga. get some banshee hydro's. i have rear ones, you just need piece of aluminum or something machined to hold the on where the stock brakes mount, then you will need a small mount welded on your frame. ill get pics later.
quadracer04
08-30-2005, 06:37 PM
The trenga brakes suck ***!! Your best bet is banshee rears like Flyin said.
kfxwizzard400
08-30-2005, 08:50 PM
well guess u didnt try them