4:1 offset hipers

[iride47]

I just ordered a set of 4:1 offset Hipers and I am not sure if they are 4:1 or 3:2. My Yamaha 4:1 hipers are flat. The center section goes all the way out to the ring. The Honda is recessed a little bit. Does anyone know if this sounds right or do I need to take them back. I have plus 2 arms and it does not seem like the wheels made it any narrower. It looks like the front tires are wider than the rear. Aren't they fronts supposed to be narrower than the rear?

[rowlrag]

You can tell a 4-1 cause the aluminum center is flat, a 3-2 difference is that the lug nuts are recessed in the center, understand my explanation?
Now there newest 4-1's use the same looking center as a old 3-2 (recessed nuts) but they changed the inner and outer halfs. If you used these new wheels with an old 4-1 center that would be even narrower, as long as everything lined up.

[megadeath]

LOOK ON THE INSIDE OF THE FRONT RIM
IF HAS
A SINGLE (F) AT THE END IT IS 3-2
FF = 4.1
HOPE THAT HELPS