300ex73
03-15-2005, 08:45 AM
If anyone out there is running the IMS/Roll Design ProPegs, could you please take some measurements for me.
I need the width between the bolt holes that are used for the nerfs/heelgaurds.
The width from the mounting pad of the peg to the nerf/heelgaurd bolt hole nearest the frame.
The distance from the back edge of the peg to the bolt hole on the frame used for the upper mount on heelgaurds.
If anyone could PM me with these measurements, it would be better, and would be incredibly helpful. Thank you.
I need the width between the bolt holes that are used for the nerfs/heelgaurds.
The width from the mounting pad of the peg to the nerf/heelgaurd bolt hole nearest the frame.
The distance from the back edge of the peg to the bolt hole on the frame used for the upper mount on heelgaurds.
If anyone could PM me with these measurements, it would be better, and would be incredibly helpful. Thank you.