Installing warning label covers!!

[Matt37]

Hey

I just got warning label covers, however iam not sure on how to get the warning labels off? I dont know what tool to use they are on there by like little studs or something anyone take their warning labels off and how did you do it??

[nat3060]

drill them out

[Matt37]

drill them out

How? Do i just take a drill and go right through them. And also will this destroy them? Because i need to re-use them on the warning covers i got

Thanx

[nat3060]

yup, but its a rivet..u cant reuse them

ud have to put new rivets on for the new labels

you shouldnt be doing this job if you have to ask about it..

but ill elaborate..

you drill out the rivets on the stock warning plates.. that means take a drill bit to each of the fasteners on the warning plates.. then pull the plate off, then take the covers put them in place of them and re rivet them to the bike using a RIVETER and some RIVETS lol

Jesse

[Stevie-D]

sir, i am going to have to ask you to please step away from the quad....











:devil:

[Matt37]

All i needed was a little explanation not opinions.

[sampleez]

be careful with them once their off, i cut the F^&K out of my thumb with one, i think just about to the bone :scary: that sucked!!

[bulkdriverlp]

you need to use backers too, or else the rivets will pull through the plastic.