Proper break in time

[JDiablo]

Ok i just sent my motor off to get a JE 10.8:1 416 piston,hotcams stage two,hinson clutch basket,sparks 8 plate clutch,lighten flywheel,ported head and magnum rev box

I am just wanting to know what is the proper break in for this?thanks

[standardryder]

i know when i got my quad new they said to run it through 3 tanks of gas under 3rd gear. i dunno in your case tho
i would guess 2-3 tanks maybe?

[JDiablo]

yea i guess so,anyone else have input?

[roostin_dale]

Take it out somewhere. Run it low/mid through all the gears for about 15 minutes....let it set for about 15 minutes. Repeat this about 3 times. Bring it in, set the valves and change the oil....then ride it...

[JDiablo]

derk you think that is enough?45 mins on the engine and it should be good?i would at least think a tank of gas

[roostin_dale]

Originally posted by 300exrida
derk you think that is enough?45 mins on the engine and it should be good?i would at least think a tank of gas

Thats the way i've done it with all my motors. It's also what Sparks suggested to me when they built my motor....

[JDiablo]

If sparks says that then i guess that is normal,do you go and ride the chit out of it after the "breakin" is done or still take it easy on her for a bit,but still get the rev's up pretty high?

[roostin_dale]

Originally posted by 300exrida
If sparks says that then i guess that is normal,do you go and ride the chit out of it after the "breakin" is done or still take it easy on her for a bit,but still get the rev's up pretty high?

After i do what i already said. I will ride it for a couple hours still under 1/2 - 3/4 throttle. Then give it hell...

[JDiablo]

ok cool,ill just prolly want to set the valves and get the rings and everything set,word iight thanks bro