swingarm pivot bolt

[Dannys400ex]

ive beat on this fkj'ksdj'ksdjksdgf bolt for 4 days and it still wont budge. i have since then got a sawsall, but dont know how and where to cut it without hitting the case. where do i need to cut it?

[gump]

you need a damn suki !!!!!!!!!!!!!!!
just kidding danny, you gotta quit abusing the damn thing, it can only take so much !!!!!!!!!!:blah:

[Rico]

Cut it on both sides of teh swinger. Both inside and outside.

I know it sounds like a lot of work but pull teh shock off and subframe and everything else in the way so you can get to it better.

Get a pivot works bearing kit, and call Jeff@quadshop and get a greaseable pivot bolt. I've had mine in for over 2 years and it's still is in good shape and comes out with ease everytime....:cool:

[zephead400ex]

How much $ do those run Rico?...well you might have gotten a good deal on yours...how much would it cost the average joe? Or do you know?

[duke416ex]

LAST i checked, a few months ago, you could get swingarm bolt and nut for around 25 at planet honda.

[bens250ex]

i had to finally cut mine it pissed me off so much

[Jingle 11]

everyone always had problems and mine was a 99 but it came out easier than i thought.

[Fred55]

Originally posted by duke416ex
LAST i checked, a few months ago, you could get swingarm bolt and nut for around 25 at planet honda.

But that one isnt greasable!

[Juggalo]

i had to cut my stock one out too...it sucked. but i replaced it with a billet stainless one and its niiice