ny300exrider
03-03-2005, 02:06 PM
i read lukesters post in the faq forum over at trx450.org and its very helpful but i need to ask some questions about it. I'm running a pro design kill WITH the key still in. Since there is no pictures for the part about doing it with the key left on i need some help. I traced the wires from the on off to the white connecter and disconnected the end. This is where i am at right now. I see the black wire with white tracer but im not sure how i should splice into it. The wire has the half of the connecter attached to it, do i cut the wire off at the end removing it from the switch, then tie it into the kill? or is there a better way to splice into it. Im not going to cut anything until im positive on what to do. any help is appreicated. Basically i just want to know how and where on the black/white wire can i connect it with the kill wire. also one last question, the other wire from the kill goes to a ground. what is the best way to ground the wire without using solder. Should i run it through a bolt into the frame? any help is GREAT
Thanks!
Thanks!