couple quick q's....

[dtmichau]

This may sound stupid but is it ok to drill holes through carbon fiber for my oil light and ket start? I have the holes drilled for my key and oil light in the stock hood right now but i just bought a carbon fiber one and was wondering how the carbon fiber material takes to a drill?

I cant find my owners manual and was wondering how many ounces of coolant the 450R holds?

One more question :)......i have a few quarts of synthetic blend oil in the garage left over and was wondering if that is ok to run in the 450R. Im about to install a hotmcam camshaft and it says not to use systhetic blend oils, only petroleum based. The owners manual states the same. just wondering if it was the manufacturer trying to play it safe or if it is ok to run the sysnthetic blend oils?

[mini mouse]

yes you can drill in carbon fibre just take your time. sorry don't know abut the other Q?.

[brandonpeake]

for breakin use the petroleum oil after that i always run syn , ive been running syn in my R since initial breakin with no probs and im about to break in the new motor with a hotcam and ill use pet oil then go back to my amsoil syn

[ATC350X 85]

Its a coolant light not an oil light.

[dtmichau]

thanks atc350X :rolleyes: :) . anyone know how much coolant the 450r holds by chance?

a little less than a gallon i do believe but dont hold me on that

[mini mouse]

I say fill it up till it full

[kargaaro]

I think it's only about a quart and a half.

[ATC350X 85]

Check the owners manual it should say it in there somewhere.