C&D head gasket thickness

[crazyatvn]

I have 11.5-1 compression 440 stroker. It uses a 416 87 mm piston. I would like to run pump gas what thickness would I need to lower it to run pump gas?

Help would be great

[cals400ex]

i think the stock thhickness is the thickest one you can get. just get one for a 416 bore. i don't know about those powroll strockers. i don't know if those compression ratios are correct or are a bit low.

[crazyatvn]

does C & D have a website?

[cals400ex]

i think it is www.cdracingonline.com

they probably won't have this on their site though. their phone number and location just changed and they may not be updated on their website yet. look in the C&D forum on this site or post a thread in that forum and they will get back with you.