PDA

View Full Version : Welding plastics???


chucked
02-21-2005, 02:05 PM
I almost bought this yesterday...

http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=41592

Wonder if everyone has ever tried it, what it basically does is blow very hot air out in a small stream, so u basically melt the plastic back together, they also sell plastic welding rods.
hardkoratvmxr
02-21-2005, 02:09 PM
i have one similar to that but for it to work right you have to get your plastics very clean and i mean clean. and take your time
beak7707
02-21-2005, 02:32 PM
My friend has one that is like a little iron. It gets hot and melts a grove in the plastic then you fill it will a clear plastic rod that the iron melts into the groove. It works pretty good and the clear filler plastic blends with whatever color the plastic is.
quad_62
02-21-2005, 08:19 PM
i have one and used it on my 400ex...

http://www.imagestation.com/album/pictures.html?id=2132567888
450ar
02-21-2005, 08:28 PM
a hot glue gun ?
wheeltrax
02-21-2005, 08:43 PM
Originally posted by 450ar
a hot glue gun ?

No, its a plastic welder.
YFZ450Ridr
02-21-2005, 10:25 PM
would a hot glue gun work to fix cracks in plastic? if you used a colored stick that matched the plastic, or a clear one.
chucked
02-22-2005, 05:02 AM
Originally posted by 250EXridr
would a hot glue gun work to fix cracks in plastic? if you used a colored stick that matched the plastic, or a clear one. highly doubtful
XANDADA
02-22-2005, 06:28 AM
That would be a lot cheaper than the plasma welder we use at work for plastic. Give it a try...
chucked
02-22-2005, 07:32 AM
Originally posted by quad_62
i have one and used it on my 400ex...

http://www.imagestation.com/album/pictures.html?id=2132567888 that doesnt look all that bad!
standardryder
02-22-2005, 08:45 AM
speaking of plastics, is it not good to cut the plastics for air cooled engins? i heard that it makes less air get to the engin makin it run hotter. iacutten them on my 300ex.
standardryder
02-22-2005, 10:01 AM
i was thinkin about cutting them on my 300ex**
wheeltrax
02-22-2005, 10:41 AM
I doubt that it makes that much difference. Most people here that have cut fenders have an air cooled machine. I have cut fenders on my 400ex and i havnt had a problem. I had cut fenders on my 250x and didnt have a problem either.