Jetting Help...

[edz250r]

Hey guys....I'm switching my stock 34mm carb and replacing it with a 38mm air stryker. The jetting in the stock carb was 172 main and 45 pilot with needle at middle clip. I opened the air stryker from the guy I bought it from and he had 192 main and 50 pilot. I'm not sure what his mods were, but 192 seems high.
My mods are as follows: uni foam filter with vented lid, rad valve, mild port with 20mm dome, esr trx 5 pipe and silencer. I ride at sea level.
Should I put the 172 main in the air stryker and go from there? Does the 50 pilot sound right for my setup?

Thanks!!

[zedicus00]

i would bolt it up as is and try it. the only thing u will hurt by being to rich is possibly a couple plugs... then u can lean it out from there.

[edz250r]

Does the 50 pilot with needle clip in the middle sound right with this carb and my mods? I know I proably wont know until I ride it, but I'm just trying to get it almost spot on before I begin to ride...