Pro Design Kill Switch [Archive]

View Full Version : Pro Design Kill Switch

Dodge 1 Ton

01-29-2005, 03:27 AM

I bought a Pro Design Kill Switch and I am not sure which wires I need to cut into on My YFZ. The switch is normally open and closed when you pull the clip. I went back 60 days on the forum and did not find anything about it.

Thanks

jshtex

01-29-2005, 07:52 AM

This works, its what I did.

http://www.bluetraxx.com/phpBB/viewtopic.php?t=38233

Dave400ex

01-29-2005, 08:55 AM

I think the Baldwin wiring kit is the best way to go. Don't have to mess with cutting the wires. Baldwin Kit (http://www.baldwinmotorsports.com/index2.html)

SRH

01-29-2005, 12:37 PM

Originally posted by Dave400ex
I think the Baldwin wiring kit is the best way to go. Don't have to mess with cutting the wires. Baldwin Kit (http://www.baldwinmotorsports.com/index2.html)

i dont think the baldwin kit is a very good way to hook it up....

SRH

01-29-2005, 12:40 PM

http://www.exriders.com/vbb/showthread.php?s=&threadid=107004&highlight=aussie go there if its not the post click the one posted by me called aussie rider way...thats the best way to hook it up, and only use that or the switch for emrmergency to sht it off, use the key otherwise

Dave400ex

01-29-2005, 01:42 PM

What is wrong with the Baldwin setup?

SRH

01-29-2005, 01:54 PM

Originally posted by Dave400ex
What is wrong with the Baldwin setup?

it grounds to the frame which i beleive is bad to do on ht eyfz and can burn out the stator...im not taking any chances

mountaineer

01-29-2005, 06:24 PM

I use the balwin kit without any trouble. Easy to hook up without cutting any wires.

SRH

01-29-2005, 10:00 PM

i didnt have to cut any either with the way i did it

Dodge 1 Ton

01-30-2005, 03:38 AM

Thanks for the info. I believe I will try it the SRH way first.

Dave400ex

01-30-2005, 12:50 PM

I think I'll try out the Baldwin setup first...

5valves

01-30-2005, 08:52 PM

There are two companys that make N/C kill switches.
One is Pingel and I dont remeber the other.
Hook them inline with the power wire going to the on-off switch.
No grounding of the ignition wires.
Bob from Magnolia has the other kind in stock. You can get the pingel from them or I think other people carry it.
Good luck grounding your electrical system on this quad. You might end up with a problem down the road.