what should i use to cut my 400ex fenders?

[400exrider101]

what should i use to cut my 400ex fenders?

thanks, bronson

[sharkinthepool]

Good grinder or a good jigsaw as long as you have a fine tooth blade and some packing tape!

(packing tape will keep the fender plastic from fraying so bad).

Then hit them with a good palm sander or do it by hand to take the edge off of them and make them look factory!

[ZSK]

With polyproplene you can score it and then just snap it off. ;)

[400exrider101]

ight thanks

[DGR]

Originally posted by ZSK
With polyproplene you can score it and then just snap it off. ;)

excuse my igorance, but what do you meen by "polyproplene" ?? :confused:

[ZSK]

Sorry I spelled it wrong, sometimes I think faster than I type. Polypropylene is the type of plastic that fenders on ATV's are made out of. Polycarbonate is the clear plastic, like headlights and taillights.

http://www.dunereview.com/video/w-lt250rrace1-3.wmv


CHECK OUT THIS RACE OF A 400EX VS LT250r AND 1 KID ON A RAPTOR660 AND A RAPTOR660R THA CAN HANDLE THE POWER

[2001300exguy]

hey pitbull quit being a post whore ive seen that vid link at least 6 times now plus that has nothing to do with 400exrider101's question

[JOEX]

pitbull has been taken care of.

[400exnac]

What should I use to cut my 400ex fenders?

Roto-Zip works great.

[honda400ex68b]

i used a utility knife with a brand new blade. worked fine, no smoothing of the edge's needed. just be careful when pulling the knife, i had a few close calls doing it that way, but turned out good. tape the fender how you want it, then follow the tape. not much trimming that way.

[muddy400EX]

i heard a chainsaw works the best

[muddy400EX]

Originally posted by pitbull racing
http://www.dunereview.com/video/w-lt250rrace1-3.wmv


CHECK OUT THIS RACE OF A 400EX VS LT250r AND 1 KID ON A RAPTOR660 AND A RAPTOR660R THA CAN HANDLE THE POWER


WOW! a 660cc quad beat a 400cc quad! I CANT FREAKIN BELIEVE IT. who gives a crap, a drag race takes no skill at all:rolleyes:

[honda400ex68b]

Originally posted by muddy400EX
i heard a chainsaw works the best

I heard it worked in Texas Chainsaw Massacre!

[Plante400]

I used a hack saw...

a file..
and duck tape to outline where i wanted to cut
its kind of time consuming to get everything exactly right but it looks saweeeeeeeeeeeet

[Plante400]

file...?? i think its spelt different but

not the paper ones hahaha

[400exrider36]

i used tape, a jigsaw and a file, or however u spell that?

[brian350rx]

I used a Dewalt cut out tool - its kind of like a router, uses a drill bit to cut and it worked very well cleaned it up with a file and sand paper.