300EX Front Sprocket Please Help!!!

[94EX]

Hey all, I just got a chain and sprocket kit from Primary Drive for my wifes 300EX. The only problem I am having is that the holes on the plate that goes over it dont line up with the holes on the sprocket. Am I doing something wrong??? Thanks in advance for all the help and advice.
:ermm:

[PunkA$$]

Umm you have to turn the plate so the holes line up with the sprocket and the tabs (on the plate) DO NOT line up with the splines on the shaft. Kinda hard to explain, but maybe you're talking about something else entirely.

[400exdad]

I think you may have the top "clamp" on upside down too..... the holes are not 180 degrees apart... if memory serves me right.

[bradley300]

Originally posted by 400exdad
I think you may have the top "clamp" on upside down too..... the holes are not 180 degrees apart... if memory serves me right.

you are correct

just have to play with it, you'll get it on. and when its on, the sprocket WILL wobble, so dont try to overtighten the bolts trying to get the wobble out

[sprtrx300ex]

once you put the clip on al the way, theres a grove it sits in that allows you to run it a little bit.

[94EX]

thanks for all the help. Im still a little confused but I am going to try to work on it tonight. Any more info is always appreciated.
thanks again

[bradley300]

i think once you look at it after reading this, you'll probaby ave it;)

[frosti108]

lol yea i remembering having trouble with that...
i forget what to do, but i remember it was soo easy and i felt really stupid afterwards lol

don think too hard. its an easier conclusion than your looking for...

when you get it, youll feel like honda made it like that just to confuse and trick people :devil: