Houser Maintainence ?

[sprtrx300ex]

I have LT housers.

What all do I need to do to make sure my upper balljoints keep in good shape and properly lubricated? It doesnt have a rubber boot, so its prone to dirt :confused:

[nwi45]

I have LT Houser's also, and was wondering that same thing.

[416exmx]

Tri-flow works good. You should have a rubber boot that goes over the joint. On the Housers I had, I had to adjust them all the way in where I couldnt use the boot...

[sprtrx300ex]

What is Tri-flow? Is that a lubricant? Where can I get it?

[nwi45]

Mine don't have the rubber boots..Is there somethin I could buy from Houser to replace them? What about the DeRisi Racing Ball Joint Covers for Roll Design A-Arms...would those work?

[sprtrx300ex]

I was just looking at houser's website ( houser-racing.com) and they have some boots.

[Rootar]

triflow is basically a bearing lubebricant works wonders for ballbearings (skateboards) you can find it for liek 5 bucks at any local skateshop or bike shop its pretty amazing stuff on bearings i dunno how itll work on ball joints though