300ex PROBLEM HELPPPPPPP!!!!!

[300exryder03]

ok heres the deal i just recently switched my 300ex back over to my frame. Every thing is on rite but i went to start it and no power. im not even getting a nutral light signal. now i checked all the wire connections and fuse's. all of them are on correctly and the fuse's are fine. also the battery is charged aswell. does any one have any suggestions or could help me out. thanks

check all the wiring again.....make sure everything is connected right

[exrider360]

its wireing


go and check everything

[notfastenuf4me]

did u powder coat the frame if ya did u have to clean the powder coat off the frame where the grounds go it sounds like a bad ground 2 me

[Hon300ex]

check all the wireing because you say your not gettin the nuetral light and your battery is fine. It may be one wire that messes the whole project up.

[bulkdriverlp]

gotta be a ground. get 12 volt test light and start at the battery and start pokin wires find out where ur lackin power

[300exryder03]

here it was the ground. i thought that i sanded some of the paint off for the ground but i guess not. thanks guys for the help.