hmf full system

[yel400]

I have just installed a hmf full system on my 400ex the clutch cable is sitting against the header pipe do you have to reroute this or will it melt this cable

[schootar]

I would say that it will melt the cable. If you can't reroute look into some spark plug wire heat guards. I bought some about 4 years ago for the wires on my Bronco that were close to the headers and they are still holding up fine. I ordered them through Summit, but I don't remember what brand they were?

[Hon300ex]

You should reroute it cause it will definitely melt the calble. How is the full hmf pipe? How much power does it add? Please tell us if you can.

[yel400]

i have not ridden it yet sounds good and the quiet core really quietens it down i have tried to reroute the cable but it is not long enough to go any other way

[crazyelece]

You may have to buy a longer cable or an inline adjuster would give you a couple inches. If you can put up a pic so we can see where it is and may give you suggestions on rerouting.

[cals400ex]

my buddy currently has a zip tie holding it away from the header. also, try bending the black little bracket that the cable runs through.

[brian-250]

heat tape around your headpipe where it rubs.;)

[tp300ex]

twist tie it to the frame thats wat i did:devil:

[J M B]

I had the same problem after I put on the ballance full system.
Just call up www.motionpro.com and they will custom make any lengh you want.

Jason

[Dave400ex]

I just got my full HMF and had a custom +2" Terry Cable made. It works well and is not close to the headers at all...