need quick response

[YFZ450Ridr]

yes i know this should be in the powertrain section but i get faster responses here.

ok im putting in my new swing arm bearings right now and in the kit i got from all-balls racing there is are bearings, a rubber bushing, and a metal cap like thing. i got the stock bearings and bushings out but there is no metal cap like in the kit i got. the bearings and the bushings fit but i dont know where this metal cap fits in there any help is greatly appreciated!

[baker250r]

it is either your dust cap, or something else. but it does go on the end of both sides inbetween your swingarm and your frame. We are replacing swing arm bearings in both a 250r and 400ex right now, and thats what they are. the rubber seal goes between the cap and the bearing. I dont know if the 250ex has a solid swing arm like the 250r, or one like a 400ex. hope this helps you.

[markk]

All i can tell u is what this guy said. Im not 100 percent sure but i think its a solid swinger! (right or wronge) Im guessing it goes on the end inbetween your your swinger and frame!

[rider250ex]

r u sure it isnt the dust cap for the bearings at for the axle?

[markk]

R u talking about swing-arm bearings, or Carrier Bearings?

[rider250ex]

there really isnt to much of a carrier on a 250ex seeing its shaft drive. i think the caps you are talkin about are the ones that cover up the axle bearing.

[markk]

Originally posted by rider250ex
there really isnt to much of a carrier on a 250ex seeing its shaft drive. i think the caps you are talkin about are the ones that cover up the axle bearing.




Im thinking about the dust cap that fits between the frame and the swinger. and I know that there isnt a carrier in the pumkin But there has to be somthing to seal it i figgured!