View Full Version : yfz450 killswitch install
balls2da-wall
01-17-2005, 07:09 PM
im helping a friend wire up a tusk kill switch on his yfz...can anyone tell me what wires to splice the switch into? If you are not familier with the tusk kill switch when the switch is depressed the circuit is broken...when the kill switch is engage the circuit is closed. Any help would be appreciated!
wheeliemaster
01-18-2005, 02:53 PM
hey, you have to take the front plastic off and i think it is a red or green wire but i will check when i get home and i'll post again to tell you.
balls2da-wall
01-18-2005, 04:01 PM
red or green wire from the ignition?
wheeliemaster
01-18-2005, 04:54 PM
Take front plastic off, then look behind left headlight you see a connector with 2 wires coming out of it, 1 white 1 yellow . you spline into the white wire and the yellow wire is ground. hope that helps!
balls2da-wall
01-18-2005, 05:34 PM
sorry im confused...so i connect the two wires of the kill switch to the yellow and white wires?
wheeliemaster
01-18-2005, 06:37 PM
on the kill switch there should be 2 wires coming of of it, 1 wire is for splicing into the white wire that and that goes into the eltrical system and the other wire on the kill switch just bolts to the frame or were ever to ground the killswitch out.and then you can mount the killswitch to you handlebars and it is ready for use.
wheeliemaster
01-18-2005, 06:39 PM
yes
balls2da-wall
01-18-2005, 06:56 PM
haha alright...sorry im not used to yami's...im a honda man!
Thanks!
wheeliemaster
01-18-2005, 06:58 PM
it's alright i had a honda to before i bought my yfz
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.