Help with electrical

[crazyriles]

Well i just got my hood and i am taking out the wires that you dont need. My question is which ones do i remove and do i remove the condenser which is on steel brackets?

[crazyriles]

does anybody even know if your supposed to remove that black rubber cylinder (condenser), which is attached to the steel brackets that hold the lights to the frame, when removing the lights,keyswitch,etc?

[team_450_88]

you can jus zip tie it to the frame...I ran into tha same problem...but come to think about it the bracket on the headlights might even come off thelights and bolt to the frame and not be in the way of the hood and u can jus slide the piece on the bracket

[roughrider01]

You keep it in the same spot just unbolt the headlight, it wont get in the way of the hood,

[jasson450r]

mine didn't
you loose the temp light, i put it in the side

[roughrider01]

If you talking about just puting a new hood on, the condensor or whatever it is stays there. If your puting on new bars, mount the key switch/ temp light to the fenders or the hood.. hard to tell what your asking.

[jasson450r]

my hood was fine and put the temp light in the front side panel under the hood by the trx

[crazyriles]

Well im going to be removing the key switch so do i remove the the temp light? I will just be racing mx only so i dont have to worry about it overheating.


And jasson450r are you saying the condenser is for the temp light only?