PDA

View Full Version : Tilt type quad trailer for sale



noreversesucks
01-07-2005, 11:41 PM
Need to sell this.
4'x7' tilt bed
Automatically latches when you lower it back down.
Small winch mounted on it, (boat winch hand crank type),
Built in stand for the tongue.
Spare tire holder but don't have a spare for it.
2" ball
Just painted it Black cause I didn't figure very many people would want a yellow trailer. I won't lie and say it's a high quality paint job, it was just spray canned.
It's served me well for many different things but it won't work with my 2+2 a-arms and +4 axle.
For a stock width quad it is great.

Right now it needs tail lights but I'll put new ones on it and wire them up before it sells. I took the old lights off to paint it and they were pretty much shot anyway.

Asking $300

Might be able to meet halfway or maybe even deliver depending on my truck situatiuon, (just putting the trans in my S-10 now), and your location for gas $.

http://www.imagestation.com/picture/sraid153/p5980303989a735eb9acc68424b26050c/f592212d.jpg

http://www.imagestation.com/picture/sraid153/p4a86e2a3465528f7bebaeb2a3d2a3b37/f5922533.jpg

http://www.imagestation.com/picture/sraid153/pb3ff4168f75c87efc151b591130af915/f592275e.jpg

http://www.imagestation.com/picture/sraid153/p947d76f68f6b6edde84256b74fa04f96/f5921b53.jpg

noreversesucks
01-10-2005, 09:49 AM
Dayumm...4 pages back in 2 days!! Alotof traffic here!!
Anyway, Bump ttt and sale is pending

noreversesucks
01-10-2005, 10:09 PM
Potential buyer backed out. Still for sale.
ttt

jesshamner
01-10-2005, 10:33 PM
Sent you a pm.

noreversesucks
01-10-2005, 10:50 PM
Got your PM jess.
Not a chance. Sorry

jesshamner
01-11-2005, 12:14 AM
Never hurts to try. I just through that out there b/c I saw a 5x10 tilt for 300 and it had all the lights and was painted from the factory. Didn't mean to insult you.

noreversesucks
01-11-2005, 06:53 AM
Mine will have all the lights before it's sold. I didn't see any reason to put them on until somebody decided to buy it for sure. All the brackets are there for them so it would only take about 10 minutes to put them on.
The factory painted one probably has a better paint job but then again probably 80% of mine is galvanized metal to start with. All the angle iron and the floor are all galvinized.
5x10 will still only haul 1 quad so you don't gain much there either.
The axle itself will cost more than $100 then there's the tires/wheels, lights/wiring, 2in. ball hitch, fenders.
$300 won't hardly buy these parts alone and that's not counting the angle iron,square tubing and sheet steel.
Your right though, never hurts to try.:D

TDBRPH
01-11-2005, 10:48 AM
what part of missouri?

noreversesucks
01-11-2005, 11:17 AM
Northeast corner, just outside of Kahoka.