better vavles

I have a 95 300ex.I just installed a new cam chain,new guides and the cylinder is being bored out .080 over.And of course new piston and rings.11:1 h.c piston that is.My head is ported and polished and I have a DG pipe, front to back.I am looking into a better cam as well before the motor goes back together.So my question is should I touch the vavles.And if I should what should I do.Thanks Twerker.

[DEAL]

Get a 3 angle valve job , i don't know if anyone around here does it though.

Most all valve jobs even stock are three angle 30 45 60 . If your valve seats are bad, and if you have to have them recut, go with a two millimeter bigger valve with already being ported this should make a good increase. Hope this helps.