trail tech installation

[Sprks450r04]

how do u wire the trail tech lights when the stock headlight is off to the high beams

[Sprks450r04]

anyone??? c'mon

[300exr]

What you wanna do is first get the stock lights n all the crap off. Theres a little square thingy that has high, low, and ground wires to it. The green is the ground and I'm pretty sure blue is the high beam. Then youl wanna take one wire out of the two coming out of each torch light and put one to the ground and one to the high, and make sure you solder them good. Check if the lights work when the high beam(or maybe low beam) is turned on. If it works tape evrythin up really good and your set. I have trail tech torchs on my 300 and thay look really good and and are brighter sumwhat than stock. Hope this helps.

[300exr]

you can see pics at
http://forums.atvconnection.com/mypage.cfm

[EPDP99]

you can do that or look into putting both power wires to one then connect to lights. this should give go power on both settings. this way the will come on no matter what position.

[300exr]

one wire has to go to the ground though, or else it wouldnt work.