04-22-2002, 08:13 PM
I am in the process of fixing up my 1986/1988 Honda TRX250R for local Motocross, but I am not sure which parts I should go with. Should I use....
Lonestar Axle OR RPM Dominator Axle
PEP Shocks OR TCS Shocks (can't afford axis shocks)
Holeshot MX tires all around OR Radial fronts and Grooved Turfs for the rear
Lonestar A-arms OR Roll Design A-arms
Hiper Technology Carbon fiber rims OR Beadlocks all around
AirManDan
1986 TRX250R, bored 40 over, V-Force Reeds, ESR TRX-6 Pipe, ESR Silencer, Keihen 36mm carb, Sidewinder Sprockets, Hinson Clutch Basket, Nac's Case Saver, TM Designs Chain Slider, Renthal Handlebars, CR250 Clutch lever and Perch, Lonestar Supertwin bearing carrier, Pro Design Kill Switch, Pro Design Power Shifter, Shredders all around on Douglas red labels, and a Clarke 4 gallon tank.
Future Mods: New Set of Plastic, New Seat, Graphics Kit, Lonestar Steering Stem, RPM Dominator +4 axle, and Some GBC Paddles for the rear on red label rims.
Lonestar Axle OR RPM Dominator Axle
PEP Shocks OR TCS Shocks (can't afford axis shocks)
Holeshot MX tires all around OR Radial fronts and Grooved Turfs for the rear
Lonestar A-arms OR Roll Design A-arms
Hiper Technology Carbon fiber rims OR Beadlocks all around
AirManDan
1986 TRX250R, bored 40 over, V-Force Reeds, ESR TRX-6 Pipe, ESR Silencer, Keihen 36mm carb, Sidewinder Sprockets, Hinson Clutch Basket, Nac's Case Saver, TM Designs Chain Slider, Renthal Handlebars, CR250 Clutch lever and Perch, Lonestar Supertwin bearing carrier, Pro Design Kill Switch, Pro Design Power Shifter, Shredders all around on Douglas red labels, and a Clarke 4 gallon tank.
Future Mods: New Set of Plastic, New Seat, Graphics Kit, Lonestar Steering Stem, RPM Dominator +4 axle, and Some GBC Paddles for the rear on red label rims.