View Full Version : installing a kill switch question
zzbudzz
04-21-2002, 11:24 PM
i ordered a kill switch (pro design )today .where do i hook it up at ?the coil ? i have a honda 400 ex manual, so i have a wiring diagram to go by .i'm just not sure where on the quad to hook it up at?any info would be nice .
Atomic83
04-21-2002, 11:29 PM
Read This
http://209.120.142.52/showthread.php?s=&threadid=12510&highlight=kill+switch
you can mount the switch to the bars, and just splice into the coil and ground wired that run to the factory off-run-off switch, that's what I did...
there is a wiring diagram in the back of the book that lists the wire colors, if you can't figure it out let me know and I'll go look on mine later and let you know the wire colors..
Leo
MoparTrav
04-22-2002, 09:08 AM
i did this, just sat., and what i did was ground the ground wire, and splice into the wire coming off the coil, i believe it was black with a green stripe.
R-Crazy
05-02-2002, 06:31 PM
would it be the same with a 300?
dave
Powered by vBulletin® Version 4.2.1 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.