Arias 305cc kit?

[Cody_300ex]

Does anybody have this kit in there 300? What kinda power are you gettin out of it? I looking to get it but i can't find a place to buy it anywere.

[JDiablo]

try hetricks i think,i remember a engine builder site in the links section that has that kit,but i would go higher then 305

[Cody_300ex]

I dont have that kinda money! The reason I want the 305cc kit, so I can stay near the 300cc limit so I can race a national if i want. Plus if i was to send my motor to an engine builder it would be GTThunder for a 350 kit. :D

[JDiablo]

lol i say go with the hetricks 310 kits for 300 or w/e it is

[Cody_300ex]

Originally posted by 300exrida
lol i say go with the hetricks 310 kits for 300 or w/e it is

Oh, so your buy eh? Then go on ahead and make that a GTthunder 350 kit. :D

[JDiablo]

well i just keep them 40 bones u just sent me then:D

[Cody_300ex]

Originally posted by 300exrida
well i just keep them 40 bones u just sent me then:D

Alright i'll send my motor to GTThunder and send the bill to ur home address. ;)

[JDiablo]

then i will wipe my *** with it and send it back:D

[buster369]

use a weisco and have the cylinder matched to a bigger piston. they are quicker revvin and have a lot of torque. they also respond well to portin and cams and other work

[Cody_300ex]

bump :o

[Kennethyfz450]

.40 over with ross piston/je then bump the compression to a 11 5 1 get it coatings on top of the piston so you can run whatever gas you choose.. pick out a cam.. not hard ..??

[dirtmomma]

I race w/ a gal that has a 305 kit in her's & I did ride it once & from what I could tell it had good pull & good power!!

I'm in the process now of trying to bump mine up, I have a 75.5mm Wiseco piston w/ WEB cam #3, porting,400 carb, we don't want to have to bore the cases ect. for a 330 kit, so we are thinking of going w/ a 76mm piston BUT that only takes it too 298cc's :grr: I would really like to get it to a 305 cuz her's runs strong!!

[Cody_300ex]

Originally posted by Kennethyfz450
.40 over with ross piston/je then bump the compression to a 11 5 1 get it coatings on top of the piston so you can run whatever gas you choose.. pick out a cam.. not hard ..??

I already have a .040 weisco 11:1 piston in there but its just not gunna cut it, In my local series i have to run w/ 400ex's, but in the gnc circuit im runnin w/ blasters, 300ex, and 250xs. I've already picked out a stage 3 .335 web cam. Im also on a VERY tight buget! Im only 13 so it's kinda hard making a lot of money.