adeezy9183
11-05-2004, 01:27 PM
hey guys i am looking to convert the ex to a 416 because they are the most reliable next to a 426. my plans are as follows:
je piston kit - 416
oversized valves and 3 angle valve job
stage 2 hotcam
port and polish
air scoops
that is what i have so far. what brands and sizes of valves do you guys recommend because i am looking to send my stuff away to C and D. if you guys have had them do work for you before, how did it work out? good or bad. also how much of a powergain is there and around how much did it cost for everything including shipping and all because i need an idea of how much $ i am going to need for all of this junk. thanks a lot guys. andrew
je piston kit - 416
oversized valves and 3 angle valve job
stage 2 hotcam
port and polish
air scoops
that is what i have so far. what brands and sizes of valves do you guys recommend because i am looking to send my stuff away to C and D. if you guys have had them do work for you before, how did it work out? good or bad. also how much of a powergain is there and around how much did it cost for everything including shipping and all because i need an idea of how much $ i am going to need for all of this junk. thanks a lot guys. andrew