440 overuse

[440exwlspankyou]

I have a 440 setup. Now I don't have the clearance that I used to between the piston and the cylinder. Can I just bore it out a little and get a bigger piston? What is the next bigger size?

[Screamin440]

You know, I'd like to think I'm fairly knowledgeable about internal specifics on engines but your question has me sitting here scratching my head. I have NO clue as to what your question is. :confused:

Did you buy a 440 kit and just expect it to fit right in? You have to have a new sleeve pressed into the jug and then it has to be bored and finish honed.

[frogburner]

ya, that question is kinda odd.. I got my 440 done though.. runs good..

[K_Fulk]

There are 89.5 mm pistons availible.

[jerry-89-250R]

contact C&D they can get you what you need, i got a 89.10 from them and there were 2 more sizes available

[440exwlspankyou]

Sorry guys! Yeah I guess that was worded bad. I have had my 440 kit installed for a year now. I have used it so much that the cylinder wall has worn just out of tolerance. I was wondering if the cylinder walls could be bored out again. Thanks for the help