new start button

[bill]

Hi guys it been awhile , but I need info on some type of switch for start button? I will be taking off my lights and new front plastic so I do not need the stock switch assembly, any info on this will help.
Thanks, Bill,
Y34, GrandPrix, District 37

[mojoe2878]

dont really understand your question , but if your just lookin for a different kill switch and want to do away with the stock one then get a tether kill switch.

[hondarider2006]

You will want to get a dirt bike kill switch for a new start button. make sure its for a KX, YZ or RM, not the Honda CR because it grounds to the handel bars. When you get that and your teather ordered, PM me, I have this set up done on my bike;)

[airheadedduner]

You will want the yz kill button.

[bill]

On my 400ex I want to get rid of the switch assembly and just replace the start switch, I have a tether kill switch already on. I will be replacing the front plastic with one that has no lights. I do not need the lights, so that means I do not need that switch assembly but need a start switch. What do the pros use?
Thanks, Bill

[hondarider2006]

If you are getting new plastics and don't plan on using your lights, than this is what you should do. Take apart the stock unit with your start botton, kill switch etc. Look at all of the wires running into the unit and find the 2 that run to the start button. You will want to use them 2 wires to connect to the dirt bike kill button, as this will act as your new starter. Take the original unit off, and if you want to make it look clean you can cut all of the lighting wieres off and just have the 2 for the starter. I wired my teather into the wires that go to the stock killswitch, but if you already have yours wired in, than your good to go:cool:

[bill]

Thanks for the info sounds easy, will give try.
Thanks, Bill

[hondarider2006]

Originally posted by bill
Thanks for the info sounds easy, will give try.
Thanks, Bill


No problem, give us some feedback on how things work out for ya;)

[bill]

Went to dealer and he asked for 2 or 4 stroke on the switch, wasn't sure so I need to know,
Thanks, Bill

[hondarider2006]

get a YZ killbutton. Call up C&D racing, they will hook you up with what you need:cool:

[LazeR]

Originally posted by bill
Went to dealer and he asked for 2 or 4 stroke on the switch, wasn't sure so I need to know,
Thanks, Bill

Isn't YZ 2 stroke and YFZ 4 stroke ?

[hondarider2006]

damn guys...just get a killbutton off of a RM 250 dirt bike, isn't that hard....just a killbutton that has 2 gound wires, no one that grounds to the handle bars and you will be good.

[Chino]

Originally posted by hondarider2006
damn guys...just get a killbutton off of a RM 250 dirt bike, isn't that hard....just a killbutton that has 2 gound wires, no one that grounds to the handle bars and you will be good.

I have this kill switch your talkin about for a CR and it does ground to the handlebars, it was BEECH figuring out why i kept blowing fuses, if you do get one that grounds to the handlebars, wrap some black tape around your bars, then put the kill switch over it and put it on, that way it will keep it from blowing fuses ;)

[Pvt. Maggot]

^ i have the same setup on my 300ex..works great..the button is alot better then those others also...just make sure u put electrical tape around where u mount it. :)