studbacker56
10-10-2004, 03:10 PM
i have a weird problem, my rear caliper was siezed so i got one of an 02 300ex for my 250x. bolted her up and i am good to go. i go to blead everything and nothing. the pedal just keeps bottoming out. so i took the line off the top of the master cylinder to see if it was pumping and when i hold my finger over the hole it squirted and drew fluid from the resivour so it pumps fluid. but then when i put the line back on it that goes to the caliper and pump the pedal it doesent pump fluid i dont think. the pedal just keeps bottoming out.i dont think anything is bad because i have no leaks. do the holes in the line have to be matched up with the holes in the bolt? i am lost here. do i need to replace the master cylinder. im using dot 3 fluid if that makes a differance? thanks in advance, jake.