motor knocking after roll over

[fastkid400]

yesterday i was riding my 250x and was sliding around a corner and the fcker rolled. i rolled it back over, waited, when i fired it up, it started knocking. it sounds like a loose bolt, but its internal motor sounds. my guess was either a circlip popped out and it rattlin around or the wristpin. any idears, i am going to tear it down sunday of this coming week. any idears for the time being?:confused:

[hart]

man the best advice till u tear it apart is dont drive it!!!, it sounds like the rod :( , how long did it run for when it rolled over , because its quite possible the bearings for the rod where it connects to the crank can be scored or burnt out, good luck tho,

[fastkid400]

it didnt run more than a min, i know not to drive it, i just dont want to deal with the bottom end:(

[hart]

Yeah man working on the bottom end sucks mega, maby just start from the top and work ur way down , ya never no it could be somthin simple, just take ur time its worth checkin every thing , i ahte it when my quad breaks down , hope ya have good luck!

[Syrus]

Not to sure, but could it be your valves ?

[fastkid400]

right after the roll over i adjusted them. not them hey thanx guys for giving me sum input

[Syrus]

Originally posted by fastkid400
right after the roll over i adjusted them. not them hey thanx guys for giving me sum input

Np, its really hard to give out guesses when u cant hear the noise for yourself, if i think of anything ill be sure to post it.

[fastkid400]

hard to give out guesses when u cant hear the noise for yourself,

yeah it sux not knowing even for myself, until i tear it down. dam, i hope its just a circlip or wrist pin(cross fingers)