blaster help

[mxman]

hey i just got a 1991 blaster but it wont start up. i hear it crank over and sputter a little but thats it. it has spark and gas. wat else shoudl i look at could it be teh tuning on the carb if so can antbody tell me wat the stock setting is. thanks.:confused:

[XCAdam89]

try checking if your cylinder nuts and base nuts are tight. Check your carb joints(rubber piece where carb connects to cylinder) make sure the clamp is tight.make sure there is no air leaks coming into the cylinder.

[SeaDubb69]

check the reeds. i had close to the same problem and it was the reeds. on flipper thing was hanging on by a thread...im just glad i DIDNT get it to turn over, or else that probably would've been a BAD thing

[AtvMxRider]

check your reeds

[mxman]

thanks alot guy im going to check the reeds do you think the reeds could be making me lose compresion.

[Brian450]

Block off you oil injector if you haven't allready. Better to do the pre-mix then rely on the oil injector to mix it for you.

[bradley300]

did you just buy it? i bet i know your problem cause i did it too. dont touch the gas when your starting it! do this if its cold

1.full choke
2.2 pumps on the throttle
3. kick HARD, no gas

i bet it starts by the second kick even if its cold

[450 Racer R]

check your cylinder. probably need new rings and piston. If it was a problem with the carb, (improper jetting) it should start up. It just wouldn't run right.

[450 Racer R]

does it stay running if you gas it? cause mine wouldn't idle after I took it apart but it would run if I gave it gas... I unplugged the carb from the electrical system and forgot to plug it back in

[PowerJunkie]

Originally posted by bradley300
did you just buy it? i bet i know your problem cause i did it too. dont touch the gas when your starting it! do this if its cold

1.full choke
2.2 pumps on the throttle
3. kick HARD, no gas

i bet it starts by the second kick even if its cold

do you keep ckoke pulled to full?

[ATW55]

i blew my blaster up relying on the oil injector

[atvrider23054]

Originally posted by Brian450
Block off you oil injector if you haven't allready. Better to do the pre-mix then rely on the oil injector to mix it for you.

If you take the oil injector out do you have to do anything else or can you just start mixing the gas and the oil?

[tony400ex]

dom i told you dont rely on what the kid told you cause it has stock jets.. stock jets dont run with a 240 kit

[atvrider23054]

Yea, thats prob. why it ran like sh** when it ran. I just want to get this thing running! I have a feeling the problem with the blaster is the TORS. If its not that then it def. has to be the magneto.