Help please...

[jsc]

I just put in the HRC kit...minus the cam. What a PAIN to get to the needle..Anyway I have a problem. The group of crankcase lines with the "T", well there is a single one that is clamped to them that runs from the case, just rearward of the group with the "T"..Where does the other end go? The single line...Thanks

[dvsmnd]

r u talking about the line that isnt part of the three way T but is clamped with them? looks like it runs up to the top of the carb

[jsc]

Yea...just the single line...I dont think it goes anywhere but I am not sure...

[dvsmnd]

im probably not the best help 4 u but i just went out and looked at mine and if we are talking about the same line it goes up to the side of the carbs topcover.

[jsc]

No, it is just the single line, rearward of the ones with the "T". From the crankcase.

[dvsmnd]

did u look at the carb?

[jsc]

Yes, I took it off to rejet yesterday, and dont remember where, if anywhere, this line goes.
Jeff

[dvsmnd]

we r talking about the same line, iv looked at my bike 2x and in my book it goes to the carb on the same side the throttle cable goes in, the cover plate you took off to get to the needle it goes on that cover plate there should be an open spot 4 it

[jsc]

Ok, I am still unsure. There is a little nipple on top of the carb facing the same direction as the cover, I hooked it up there last night and took it off and there was pressure there, so I am pretty sure it doesnt go there. Could you give me some more hints.
Jeff

[dvsmnd]

sorry im not more help but im still new, what do u mean by pressure?

[jsc]

Crankcase pressure. I took the cover off the carb, black plastic one, and still dont see where it goes.

[dvsmnd]

top cover, not the side, u dont have to take the cover off, the nipple is attached to the top cover, with the 4 bolts and the 2 vent lines crossing it like an X. i can send u a pic of it if i can figure out how

[jsc]

OK thanks, but that nipple is blocked off. Damn I wish I had a book!

[dvsmnd]

i have a book tell me what exactly to look up 4 u, that nipple is where mine leads to

[jsc]

I am looking at the nipple on the top cover of the carb. On the right side as if you were sitting on it. The nipple is there, but its not machined out, just a nipple. I rode it last night with it routed there, and when I pulled it off it made a hissing sound, like pressure was there, and I had a few little spots of oil on the heel guards like it was causing it to blow out because of the excess pressure. Could you take a pic?
Jeff

[dvsmnd]

somethings screwy, in the book there is nothing going to that nipple but on my bike its that hose, i havent messed with that hose, i took the pic but dont know how 2 post

[jsc]

Send it to my email jcarter4143@msn.com

[jsc]

Hey I would just like to thank you for your time on this matter, your pics did the trick....Thanks again
Jeff

[dvsmnd]

:) glad i could help