RR900_Pilot
04-06-2002, 10:32 PM
What is the secret to removing the Cylinder from the bottom end???
I have followed the service manual step by step. The head came off without any problems, but I can not budge this cylinder.
I have removed the 2 small bolts on the right side, and the 4 large bolts on the inside of the engine. The piston is still in the cylider, should it be moved to BDC so that the cylinder is more free to move laterally for more leverage?
It still feels so tight that it seems like there is another bolt holding it on, but I have checked and checked again, and there is not.
Advice is much appreciated.
I have followed the service manual step by step. The head came off without any problems, but I can not budge this cylinder.
I have removed the 2 small bolts on the right side, and the 4 large bolts on the inside of the engine. The piston is still in the cylider, should it be moved to BDC so that the cylinder is more free to move laterally for more leverage?
It still feels so tight that it seems like there is another bolt holding it on, but I have checked and checked again, and there is not.
Advice is much appreciated.