300ex parts....need to sell

[JDiablo]

burgard 2+1 arms-SOLD
front elka shocks-SOLD
rear elka shock-475
burgard swinger-325
RPM axle-350
edelbrock carb-350
duncan racing bumper-SOLD
Lonestar rear wheel billet hubs-SOLD
lonestar antifade brake hub and locknut-SOLD
yoshi slip on-150 /160 with headpipe
burgard bearing carrier-SOLD
DG nerfs with pc'd mounts-55
DG grab-12
MOTOR-575 600w/carb
wiring stuff-50
airbox w/ lid-15
airboot-5
UNI airfilter-5
stem 30 or 40 with handlebar mounts that are pc'd(only top mounts)
oneil bars-SOLD
asv brake lever and clutch-SOLD
streamline front brake lines-SOLD
front calipers 15 each
rotors-15 a piece ONE SOLD
rear caliper-SOLD
SS rear streamline brakeline in black-SOLD
brake pedal-10 with that spring
master cylinder setup-SOLD
gastank-20
petcock-10
spindels-20 a piece
front hardkor hubs in red 275(BRAND NEW,NOT EVEN INSTALLED)
moose shifter SOLD
brand new O.E.M pivot bolt (installed,never rode on yet) SOLD
chains..10 a piece renthal and DID ONE SOLD
sprockets 5 for the front-10 for the rear
Frame Pc'd trans red last winter,straight,never cracked,no welds perfect condition-350(will work out price)
battery box pc'd trans red-10
motor mounts pc'd trans red 10
throttle cover with cable-SOLD

98% of the parts are less then 3 months old,all installed after the winter time(to confirm just ask silverfox)....i would like only money orders please,contact me if that is a problem,thanks

[JDiablo]

BUMP!!!!!!

[big bad beny]

is the swinger +2?
what is the rear elka shock set up for lb and mx or woods.
is the stem a roll-design?
what is the motor like?




P.S. Ride Red and Ride Hard

[JDiablo]

motor is stock,stator went so it will come with a brand new stator and gasket kit,the rear is setup for 150-170 lb rider on a +1 swinger,xc racing...the swinger is stock length and the stem is stock