a-arm bushings

[Stevo]

i am in need of some a-arm bushings on my 2000 400ex. My question is should i just get the bushings and not the seals? I also need the lower steering bushing and my questino is just the bearing or bearing and seals? Would service honda be a good place to get these?

[tigerdog]

i dont know about where you live but where i live we use a store in town for bearings and seals called bearrings unlimited .
you have to bring them the old bearrings and they mic them out.
can usually get stronger bearings for a portion of the cost of a dealer or the factory.
so if you have a bearring or industriel supply house in your area give them a shot.
they can usually save time also.
ive had very good luck with the one around here .
just a thaught
;)

[shortex]

Check out www.atvbushings.com. I have a set on my 99 400EX. They are urethane bushings that are greasable and a lot cheaper than stock replacements.

[cdalejef]

You should always replace the bearings and seals at the sametime. PivotWorks makes nice little kits with everything you need included for much cheaper than OEM.